4 controls, added an EQ knob, Dirt toggle, XLR output Improved detection circuit for smoother tones with added sustain Dirt voiced to go from warm tone enhancement to gritty tonal foundation High-quality buffer switch allows true-bypass or buffered operation for driving long cable runs Standard 9V DC Negative power, consumes less than 100mA

Retains original guitar sound without altering clarity or treble Very low noise and high amplitude that allow you to use it as Boost with saturation pedals. With the Blend button you can add the desired amount of source signal and with the EQ button you can light up or darken the bell. Works with both Humbuckers and Single Coils. Features an XLR output to connect to a console or studio interface.

The Volume control allows you to set your volume at unity or as a boost to push your amp or dirt pedals Three EQ controls to give you tons of control to cut or boost Bass, Mids, and Treble The rotary switch has three settings: Full EQ, No Mid, and No EQ Low Cut dip switch removes some of the lows if you feel your tone is too muddy and can help you cut through a mix In addition to the standard 1/4” input and output, the Clover has an XLR output for using as an acoustic or bass preamp

Small Booster. Dynamic boost adds definition and clarity. After 50% it begins to break up the valve amp for an authentic overdrive, finally achieving a tremendous sustain with a warm fuzz. It can reach up to 27dB. Operates at 9V DC Negative power and consumes less than 100mA.

A simplified and faithful throwback to classic units Mix control lets you control how much clean signal is blended in Tape Speed acts as a simulation of the tape motor speed Repeats control goes from a single repeat to many Capable of mild modulation, warble, and flutter sounds