The Volume control allows you to set your volume at unity or as a boost to push your amp or dirt pedals Three EQ controls to give you tons of control to cut or boost Bass, Mids, and Treble The rotary switch has three settings: Full EQ, No Mid, and No EQ Low Cut dip switch removes some of the lows if you feel your tone is too muddy and can help you cut through a mix In addition to the standard 1/4” input and output, the Clover has an XLR output for using as an acoustic or bass preamp

Made in Kansas City USA This pedal represents years of Josh playing around with the legendary Tube Screamer circuit and wanting to offer those changes in an affordable package You will find more clean headroom, better usability as a boost, more versatile drive and tone controls as well as a more pleasing frequency response This may be the most well-balanced Tube Screamer on earth, but that’s for you to decide Runs on 9V DC negative center power and consumes 12mA

Delay tuned for slap-back junkies Controls for Slap (time), Mix (delay level), Repeat (number of repeats), and EQ (tone of repeats) Transparent boost is great for getting above the mix or pushing an amp into overdrive Maximum delay time of about 240ms makes dialing in the perfect slap much easier Operates at standard DC Negative 9V

Small Booster. Dynamic boost adds definition and clarity. After 50% it begins to break up the valve amp for an authentic overdrive, finally achieving a tremendous sustain with a warm fuzz. It can reach up to 27dB. Operates at 9V DC Negative power and consumes less than 100mA.

The perfect solution when you need to send one signal to two outputs with the ability to choose either output (or both) on the fly Just plug in your instrument Cable (or patch Cable) into the input, then use the outputs to send signal to any combination of amplifiers, interfaces, mixing board, or anywhere else you want to send your signal Once hooked up, use the left footswitch to select between a and B channels When the led is Red, the a channel is engaged. When the led is Green, the B channel is engaged. Hit the right “Y” footswitch, and both channels are engaged for full stereo output Because the active a/B/Y has an output transformer on one of the outputs, there is no need for a ground lift as the transformer eliminates any hum